
ServicesSliding Door Replacement
Sliding Door Replacement in Carson
A sliding door that sticks, leaks air or won't lock right wears on you every day. We look at the whole opening first, including the frame, track and sill. Then we tell you plainly whether a new door is the right fix and what it takes.
When a New Sliding Door Makes Sense
Most sliding doors we replace are old aluminum units with single-pane glass. The rollers wear flat, the track bends or corrodes, and the frame stops sealing. You push harder, the latch misses, and cold air and dust come in along the edges.
Before we talk about a new door, we inspect the one you have. We check whether the frame is square, whether the sill is solid, and whether water has gotten under the threshold. You get a straight answer on what we see, with photos if it helps.
If replacement is the right call, we install a new door with tempered safety glass, a tight seal and a lock that catches every time. We are CSLB C-17 licensed, the glazing license that covers this kind of glass work in California.
What Our Sliding Door Replacement Includes
Inspection of the opening
We check the header, side jambs and sill for rot, sagging or old water damage. That tells us how the new door needs to be set before anything is ordered.
Exact measurements
Older openings are rarely square. We measure in several spots so the new unit fits snug and slides straight.
Old door out and gone
Our crew pulls the existing glass panels and the frame, then loads everything onto our truck. Nothing heavy or sharp gets left behind at your place.
New door with tempered glass
Code calls for safety glass in doors. We help you pick the frame material and glass package, including dual-pane and Low-E options.
Sealing and flashing
We set the sill level, seal it and flash the opening so water runs out instead of in. Small gaps get insulated before trim goes on.
Adjustment and cleanup
We tune the rollers and lock until the door glides and latches cleanly. Then we vacuum, wipe the glass and show you how it all works.
Signs Your Sliding Door Has Worn Out
It sticks or hops off the track
Flattened rollers and a bent rail make the door a fight to open. Once the track itself is corroded or damaged, a new door usually holds up better than patching the old one.
The lock won't catch
A frame that has shifted pulls the latch out of line with the strike. When the lock only grabs after you lean on the panel or jiggle the handle, the door isn't keeping your home as secure as it should.
Fog between the panes
Moisture inside dual-pane glass means the seal has failed. Most of the insulating value is gone at that point.
Drafts and dust at the edges
Worn weatherstripping and gaps around the frame let in air, dust and noise. You may notice it most on breezy afternoons.
Water at the sill
Stains, soft flooring or swelling near the threshold point to a sill that no longer drains. We look at this closely during the inspection.
How the Job Goes
- 1
We inspect and measure
We come to your home, check the door and opening, and take measurements. You hear what we found and what we recommend, with no pressure to decide on the spot.
- 2
You get a written estimate
The estimate lists the door, glass, labor and any repair to the opening we expect. If a permit is needed, we handle it.
- 3
We order your door
New sliding doors are made to size. We schedule your install once the door arrives and let you know what day to expect us.
- 4
Install day
We lay down floor protection, pull the old door and prepare the opening. The new frame is set level, sealed and flashed, then the panels go in. Most single doors are done in a day.
- 5
Final check
We adjust the slide and lock, clean up and show you how it works. Nothing is finished until the door runs smooth for you.
What Changes Your Price
No two openings are quite the same, so we set the price once we have seen yours. The written estimate breaks out every part of the work, so there are no surprises down the line. Have another bid? Mention it at the visit and we will compare the two with you item by item.
- Door size and panel count
- A basic two-panel door runs less than a wide unit with three or four panels. Extra height or custom sizing raises the price.
- Frame type
- Vinyl, fiberglass and aluminum each come in at a different price. We explain how each stands up to sun and salt air so you can compare.
- Glass options
- Dual-pane, Low-E coatings and laminated glass make the room more comfortable and quieter, but raise the cost. We will point out which matter for the direction your door faces.
- State of the opening
- A rotted sill or framing, or an opening far out of square, means more work. We bring this up at the inspection, not in the middle of the job.
- Stucco and trim repair
- Removing the full frame can disturb stucco or inside trim. Some doors can be installed with less disruption, and we will walk you through the tradeoff.
Sliding Door Replacement Questions
Something not covered here? (310) 340-7107
Will you tell me if I don't need a new door?
Yes. We look at the door and the opening before we recommend anything. If your door still has good years left, we'll say so plainly.
How long does installation take?
Most single sliding doors go in within one day. Wide units, or openings that need framing work, can run longer. You'll know the expected timing before we start.
Do I need a permit to replace a sliding door?
Many door replacements in California need a permit, and new doors have to meet state energy rules. We check what your job calls for and pull the permit when one is required.
Is the glass safe if someone walks into it?
Sliding doors have to use tempered safety glass. If it breaks, it crumbles into small pebbles instead of sharp shards. Laminated glass is also an option if you want more security or a quieter room.
What covers me if something goes wrong during the work?
We're bonded, and we carry $2 million insurance coverage the whole time we're working at your home. If you'd like to see proof of coverage before the job, ask when you call.
Will my floors and walls get messed up?
We cover the floor near the door and keep the work area contained. Full-frame removal can mean some stucco or trim touch-up, and we tell you ahead of time if that applies to your door.

Let's Take a Look at Your Door
We'll come out, check the frame, track and sill, and tell you what we see. The estimate is free, with no sales pressure or obligation.